<address id="h79vx"></address>
      <address id="h79vx"><meter id="h79vx"><thead id="h79vx"></thead></meter></address>

                  <address id="h79vx"></address>

                      <form id="h79vx"></form>

                         力科主頁     English     簡體中文     網站地圖
                        首頁 / 產品概況 / 

                        Lionsi CN-80

                        Organosilocone Surfactant
                        Active Ingredients:
                        Polyalkyleneoxide modified heptamethyltrisiloxane……100.0%
                        Cas Number :134180-76-0

                        Product Overview
                        CONNECT CN-240 is a 100% organosilicone formulation designed to reduce surface tension, it is not only for waterborne but all for solventborne formulations. Once added to the spray, it considerably lowers the surface tension of the water so that the sprayed drops adhere better on the plant surface. At the same time, this additive causes an effect known as “super spreading”, a process whereby sprayed drops are distributed widely and rapidly, resulting in an evenly wetted plant. Moreover, CONNECT CN-240 improves the absorption into the plants tissue of plant-protecting active ingredients. So CONNECT  CN-240 helps to optimize plant protection measures.

                        Features & Benefits
                        ? By delivering the active even under hot and dry conditions.
                        ? By insuring the penetration and coverage of weeds that are mature and hardened.
                        ? By penetrating the dust covered surface of the target plants.
                        ? By wetting and penetrating the waxy surface of weather-hardened plants.
                        ? By providing wetting when penetration in general is very difficult e.g. when a plant has only spikes.
                        ? By protecting from sudden rains hours after treatment.
                        ? By improving coverage when spray volumes are reduced.
                        ? By enhancing the dissolution of solid formulations in the tank e.g. WG and WP.

                        Typical Properties
                           Physical appearance………………………………Clear, light amber liquid
                           Specific gravity……………………………………1.0 ~ 1.03
                           pH(1.0%) …………………………………………6.0 ~ 7.0
                           Surface Tension(0.125%v/v)………………………20 ~ 22 dynes/cm
                           Flash point(close cup)………………………………>110 ℃
                           Viscosity at  25 ºC…………………………………25~90cSt
                           Contact Angle(0.125%v/v)…………………………0 ~ 4 degrees F

                        USE
                        Directions For Use

                        CONNECT CN-240 surfactant has been found to be effective in agricultural applications at 0.025 to 0.25% v/v concentration. Some applications may require lower or higher surfactant rates for optimum effect. Do not add adjuvant at a level that would exceed 5% of the finished spray volume/ When this occurs, adjust rates to obtain thorough coverage without excessive runoff. Diminished performance will result it tank mix pH is excessively high(above 9) or low(below 5). Optimum performance of CONNECT CN-240 will result between pH of 6 and 8. Prior to use of CONNECT CN-240 in any agricultural application, the user, applicator or advisor must experience or must have conducted a phytotoxicity trial on the crop to which the application is to be applied.

                        Mixing
                        Prior to any pesticide application all spray mixing and application equipment must be thoroughly cleaned. Carefully observe all cleaning directions on the pesticide label.
                        1. to prevent of minimize foaming, fill tank to 2/3 to 3/4 full of water. If foaming is anticipated, the addition of an antifoaming agent should be added before pesticides, nutrients, or CONNECT CN-240 is added.
                        2. Add pesticides and /or fertilizers ad directed by label or in the following sequence:
                        A. Micronutrients and fertilizers
                        B. Dry flowables and dispersible granules
                        C. Flowables
                        D. Water soluble pesticides
                        E. Emulsifiable concentrates
                        3. Continue agitation
                        4. Add CONNECT CN-240 and mix for 1 to 2 mixing with lower than normal agitation.
                        5. Continue filling tank, maintaining minimal agitation.
                        6. For optimum results, spray mixes containing CONNECT CN-240 should be applied within 36 hours after mixing.

                        Packaging:
                        ? Steel drum with bung 180 kg
                        ? Plastic pail 25 kg
                        ? 5 ml

                        Storage and disposal
                        Do not contaminate water, food or feed by storage and disposal. Store in original container only. Keep container tightly closed, do not allow water to be introduced into cleaning of equipment, disposal of equipment wash waters of spray waste. Do not store near open flame.

                        狠狠色丁香婷婷综合图_亚洲成在人网站天堂_中文字幕乱码免费视频_欧美成年黄网站***